Accessories for controlling the mechanical parts of the aircraft
PI1B position indicator
Part no.: ART10904
The PI1B position indicator automatically switches to minimum brightness (5 %) when dimming is off (DIM=GND or not connected). The brightness can be continuously controlled in the range of 5 to 100 % by a positive PWM dimming signal of 4.5 to 30 V. It is intended for indicating the position of the trim servo, flaps and other equipment of UL aircraft, which transmits this position using a 3-wire potentiometer. The product recognizes 9 working positions and is able to indicate fault conditions of position measurement (dropped, shorted wire). Horizontal or vertical positions can be used for signaling, therefore both label variants are supplied with the product. The subject of the order is one piece of the position indicator product.
The PI1B position indicator automatically switches to minimum brightness (5 %) when dimming is off (DIM=GND or not connected). The brightness can be continuously controlled in the range of 5 to 100 % by a positive PWM dimming signal of 4.5 to 30 V. It is intended for indicating the position of the trim servo, flaps and other equipment of UL aircraft, which transmits this position using a 3-wire potentiometer. The product recognizes 9 working positions and is able to indicate fault conditions of position measurement (dropped, shorted wire). Horizontal or vertical positions can be used for signaling, therefore both label variants are supplied with the product. The subject of the order is one piece of the position indicator product.
In stock
Basic specifications
Technical parameters
- Supply voltage: 10 ÷ 30 VDC
- Current consumption: 3 mA
- PWM dimming signal: 4.5 ÷ 30 V (positive)
- Smooth regulation brightness. If PWM is OFF then out is 100%.
- Supported position sensor: 5 kOhm or 10 kOhm
- Weight: 20 g
- Dimensions: 44×20×35 mm
Marking of conductors
| BLACK – GND | Power supply (negative) |
| RED V+ | Power supply (positive) |
| ORANGE – TRIM_VCC | Position sensor supply (+) |
| ZELENÁ – TRIM_IN | Position sensor feedback signal |
| BLUE – TRIM_GND | Position sensor supply (-) |
| WHITE – DIM | Dimming input |
Installation
The product is mounted in a prepared rectangle hole of 34.4 x 15.4 mm and two holes with a diameter of 3 mm in the dashboard of the aircraft. Wires are first connected through this rectangle hole, and then the product is inserted into the given hole and locked with a pair of screws. Finally, the respective desired label (horizontal/vertical) is stuck on the front panel.
More information
This product is not approved for installation in certified aircraft. This is not a TSO certified product.








