Accessories for controlling the mechanical parts of the aircraft

Flaps controller with display – Flaps V7

Part no.: -
The product Flaps V7 is intended for the electric control of flaps of ultralight aircraft. This version includes a lever push button switch located in the bottom center of the product and a well-arranged matrix display. The desired/current position of the flaps, or error messages, can be displayed on the display. With the display is easier to control and set the product. It is usually supplied as a set: electronic control unit + servo motor (in the case of a motor without an internal position sensor: + position sensor + 2 x protective limit switch).

Available on backorder

€296.67 €245.18 without VAT

Basic specifications

Technical parameters

  • Supply voltage: 11–16 V
  • Power consumption: 0.5 W
  • Maximum motor current: 9 A
  • Dimming signal range: negative PWM (pinned to ground)
  • Position sensor range supported: 8–12 kOhm
  • Weight: 144 g
  • Dimensions: 60 × 60 × 65 mm
  • Automatic starting of the motor (flaps) to predefined positions
  • User adjustable positions
  • User configurable LBUS pin function (one of the following):
    1. a) output for landing gear control
    2. b) input for display dimming
  • Option to use the Honeywell RTY series sensor as a external position sensor (see HBR24 material set). This sensor is automatically detected by the device.
  • Intelligent detection of position sensor, motor, undervoltage, high temperature and other faults
  • Indication of operating and error states

Marking of conductors

1 LIMSW_UP Limit switch – against flaps rising
2 LIMSW_DOWN Limit switch – against flaps lowering
3 POT_HI Position sensor supply (+)
4 POT_MID Position sensor feedback signal
5 POT_LOW Position sensor supply (-)
6 VIN(+12V) Power supply (positive)
7 OUTB Motor power output B
8 LBUS LBUS signal
9 OUTA Motor power output A
10 GND Power supply (negative)

Installation

Installation is realized in the dashboard of the UL aircraft. It is necessary to prepare one large hole with a diameter of 56.6 mm and 4 small holes for the M3 mounting screws. The device is inserted from the back of the dashboard and connected to it by screwing.

More information

This product is not approved for installation in certified aircraft. This is not a TSO certified product.

More products from category