Accessories for controlling the mechanical parts of the aircraft
HBR24 Material Kit
Part no.: ART12753
The HBR24 material kit is an expansion kit for the FLAPS unit that can supplement the installed linear actuator of flasps with a microswitch stop and a position sensor. We will use it where the actuator does not have these sensors. The microswitches detect the maximum permissible deflection (position) of the actuator. An RTY050 sensor is used to accurately determine the position of the flaps. The use and setting of the sensors are described in the instructions for the FLAPS unit.Within 3 weeks
Basic specifications
Technical parameters
- Inclination sensor power supply: from unit FLAPS (5V)
- Inclination measurement range: +-25°(50°)
- Inclination sensor life: 15M cycle
- Microswitch life: 10M cycle
- Working temperature: -30 ÷ +60°C
- Operating humidity: 20 ÷ 85 %RH
- Atm. Pressure: 800 ÷ 1100 hPa
- Weight of kit: 85g
Marking of conductors
Position sensor – EU version:
1) GND
2) VCC
3) OUTPUT
| LIMSW_UP | Limit switch – against flaps rising |
| LIMSW_DOWN | Limit switch – against flaps lowering |
| POT_HI | Position sensor supply (+) |
| POT_MID | Position sensor feedback signal |
| VIN(+12V) | Power supply (positive) |
| OUTB | Motor power output B |
| LBUS | LBUS signal |
| OUTA | Motor power output A |
| GND | Power supply (negative) |
Installation
The informative wiring diagram is shown in the product data sheet. During assembly and subsequent commissioning of the installation, follow the instructions for the used FLAPS unit.
More information
This product is not approved for installation in certified aircraft. This is not a TSO certified product.
